ePrivacy and GPDR Cookie Consent by Cookie Consent
Close

Product Support


Status:

Current Product

Warranty:

5 Years from Purchase
Full Details

Spares Available:

Yes

Serial Number:

Yes

Download Manual

Download User Manual

Full instructions on assembly and use.

PT107 10" x 7" Heavy Duty Planer Thicknesser
PT107 10

Jockey Bar Wheel Kit: Jockey Bar Wheel Kit

Tilting Fence: Tilting Fence

Cast Iron Tables: Cast Iron Tables

Swing Away Table: Swing Away Table

Rubber Out-Feed Rollers : Rubber Out-Feed Rollers

Central Thicknessing Column: Central Thicknessing Column

Independent In & Out Feed Table Adjustment: Independent In & Out Feed Table Adjustment

Wheel Kit Included: Wheel Kit Included

Thicknesser Feed Rate: 5 Metres / Minute

Cutter Block Knives: 3

Cutter Block Diameter: 75 mm

Maximum Thicknessing Height: 190 mm

Maximum Thicknessing Width: 265 mm

Maximum Thicknesser Depth of Cut: 2 mm

Maximum Planing Width: 265 mm

Maximum Planer Depth of Cut: 3 mm

Planing Table Length: 1110 mm

Motor input P1: 2.2 kW

Motor output P2: 1.69 kW

Weight: 162 kg

Size: H950 x W710 x D 1110 mm




Knowledge Base Articles
Knowledge Base Links
Feed Problem When Thicknessing

My timber does not feed through correctly when thicknessing.

The way remedy this problem is to clean the thicknesser bed thoroughly from any loose shavings, then apply white spirit to the bed with a clean rag. After this the bed should re-waxed or treated with silicon spray (part no. CWA195). Please note: do not use any oil based products on the thicknesser bed as this will transfer to the passing timber. If cleaning the thicknesser bed does not solve the problem, the cause could be either blunt or incorrectly set planer knives in the cutter block. Also make sure that a square datum face is being achieved on the planing function before thicknessing the timber.

Inconsistent Thicknessing Height

I have just started to have trouble using the thicknesser of my planer thicknesser. When I pass a length of timber through, it always lifts and gouges out the last few inches as it is not fully supported. I have tried using a roller stand to support it but it is still the same.

First of all ensure the piece of timber you are trying to thickness has been correctly planed, leaving you with a perfectly flat datum face on which to run the material on through the thicknesser. Make sure the thicknesser table is regular treated with silicon spray (CWA195) or a good quality wax to give smooth running through the thicknesser. Finally if you are still having problems make sure the knives on the thicknesser block are sharp set at the correct height.